accesstxt.jpg (12450 bytes)  
 
teasers.jpg (14402 bytes)

teasertxt.jpg (5724 bytes)

leaders.jpg (27985 bytes)
leadertxt.jpg (6385 bytes)
Bull Dawg Teasers are an option accessory that can be added to the Bull Dawg for certain fishing situations.

The Teaser is added to the Bull Dawg by pushing the wire into the base of the Bull Dawg just behind the back hook.  The Teaser should be pushed into the rubber all the way to the beads on the wire shaft.

The Bull Dawg teaser comes in two sizes and five colors.  The #4 blade is used for the regular bull Dawgs and the #7 blade for the magnums.  See above for color selection (#4 blades are shown)

The Teaser add flash and vibration while slowing the Bull Dawg down.   It can sometimes help entice a strike from following fish.

Nylon Leaders by Musky Innovations LLC are the cutting edge of big gamefish leaders.  Nearly all the pros are using mono leaders and now they are available for everyone to use.

Nylon Leaders blend into the environment making them the perfect leader for pressured waters.  They are very low stretch and are able to handle the trophy fish when it makes its once-in-a-lifetime strike.

Nylon produces more shock absorption than regular steel leaders.   You can set the hook hard while reducing the chances of line or equipment failure.

Nylon leaders are thicker than most steel leaders.  This helps protect a hooked fish while doing battle since it is less likely to cut the fish as steel is prone to do.


Solid Wire Beast Leaders -14” long

Available in 240 pound and 320 pound
$8.00 each
Made by Hayward area guide Scott Kieper –
Stay-Loc patented snaps
#5 ball bearing swivels

7-Strand wire Beast Leaders – 14” long
135#
$8.00 each
Made by Hayward area guide Scott Kieper
Stay-Loc patented snaps
#5 ball bearing swivels
Tied and crimped

 


7-Strand wire Trolling Beast Leaders – 36” long

135#
$8.00 each
Made by Hayward area guide Scott Kieper
Stay-Loc patented snaps and #5 ball bearing swivel
#6 ball bearing swivels
Tied and crimped

Beast Sucker Rig

complete 135# sucker rig
with instructions
bait needle
10 rubber bands
2 plasma point 4/0 hooks
36” leader
Tied and crimped
#6 ball bearings
Patented Stay-Loc snaps

MIFOOTER.jpg (13996 bytes)